Escalib Mills_GB

E S C A L I B M I L L S : S I T E S P I R A L S T A I R T O W E R W I T H S I D E E X I T . 31 > 1 - Remove the barrier gate. The erection guardrail must remain in the closed position. > 2 - Place the barrier guardrail on the new module.Then assemble on the Escalib Mills. Temporarily remove the couplers from the anchoring caps. > 4 - Lower the Escalib Mills again to the level of the new module. > 6 - Lower the Escalib Mills until the brackets are in contact with the brackets of the new module (or the corbels on the cursors for the adjustable brackets). Assemble again the anchoring caps to the standards of the Escalib Mills. Remove the slings from the platform. > 5 - On the new module, install the brackets (or the 4 corbels for the adjustable brackets) removed previously in step 3. With an additional set, the brackets can also be installed beforehand on the new module and as such avoid steps 4 and 5. > Principle for adding a module on a suspended Escalib Mills. > 3 - Lift the Escalib Mills to remove the 4 brackets (or the 4 corbels for the adjustable brackets). TIP Escalib coupler Anchoring cap REQUIREMENTS: > Dismantle in the reverse order of assembly. ESCALIB MILLS NT 010 - ESCALIB MILLS TECHNICAL INFORMATION