Escalib Mills_GB

W hen the Escalib Mills is far from the floor to be serviced, it can be equipped with a gangway. This gangway bears against the MDS Gangway bracket, laid on the stair strings of the Escalib Mills. The bracket is bolted directly to the front or side access gangway before lifting.The gangway is then assembled to the Escalib.The foldaway rails of the Escalib are pivoted only at the end of the operation to free up the passage. The operator therefore does not need a harness. The modular front access gangway can be tilted +/- 17% in order to adapt to the level of the floor to be serviced. These can be assembled in series up to 3 modules to form a 4m50 long gangway. The guardrails can be removed in order to facilitate transport and storage. The lifting rings are built in. The gangway can receive a universal stair at the arrival for bridging a parapet. Evenly distributed working load: 200kg/m². +/- 17% 1.50 16 E S C A L I B M I L L S : S I T E S P I R A L S T A I R T O W E R W I T H S I D E E X I T . Modular front access gangway ... > Example of front access modular gangway assembly. Gangway startV2 Front access gangway assembly Gangway arrival 4 M18-40-8.8 bolts Arteon 2 wings nut Ø23 Arteon Nut Ø23 Arteon Rod Ø23mm min. length 150 mm The gangway bracket is improved with respect to the old system and allows for assembling and dismantling in collective protection. 1.10 94 A N T I - L I F T I N G S Y S T E M BEFORE AFTER Gangway board bearer 013415-5 M DS gangway bracket 2 M12-100- 8.8 bolts Right Support 013270-4 Left Support 013271-2 The MDS Gangway Bracket can be mounted on front as well as side access gangways. We recommend delivering the gangway on the site entirely assembled, ready to be raised. max. 450 N EW 4 M18-40- 8.8 bolts NT 010 - ESCALIB MILLS TECHNICAL INFORMATION