Escalib Mills_GB

Example: An 8-module Escalib is subject to a peak wind pressure q p of 54 daN/m², which corresponds to a wind speed of 107 km/h. In configuration I, the Escalib Mills is anchored every 3 modules. Every anchor must withstand the following stresses: - shearing: V = 320 daN, - uplift:T = 200 daN. > Anchors and anchor points: This coupler can be positioned anywhere on the module standards. Compatible with the Mini Escalib. > ESCALIB MILLS COUPLER Description Code Weight Escalib Mills coupler 013049-2 2.0 Slip force: 515 daN ULS. > PLASTIC POCKET FOR INSPECTION REPORT Description Code Weight Pocket for report NC0410 0.3 Inspection report NC0427 - (A4 sheet) > Additional components: “No entry” is displayed until the inspection report has been completed and inserted into the plastic pocket. Additional components ... 11 WARNING: The drill holes of the plates at the foot are intended for nailing the wood shims when distribution on the ground is necessary.They must not be used to anchor the Mills Escalib to the ground. > 36MMWRENCH Description Code Weight Escalib Mills 36 mm wrench 013036-9 0.46 > ANCHORING CAP Description Code Weight Anchoring cap 0.50m 023050-8 2.7 Anchoring cap 1.00m 023051-6 4.7 Anchoring cap 1.50m* 023052-4 6.5  18 E S C A L I B M I L L S : S I T E S P I R A L S T A I R T O W E R W I T H S I D E E X I T . 50 - 100 -150 Downloadable from www.mills.fr 90° 0° WLL cap: 1200 daN. Range of use ESCALIB MILLS All dimensions are in mm or m. Weights are in kg. (Through-bolt not supplied). * Upon request. NT 010 - ESCALIB MILLS TECHNICAL INFORMATION