Solution integral safety

THE COMPLETE SOLUTION FOR AN INTEGRAL ASSEMBLY WITHOUT THE FALSEWORK’S AND FORMWORK’S HARNESS 2 FORMWORK WI TH I NTEGRAL SAF ETY T oday, there is a risk of falling from a height when fitting guardrails at the edge of the formwork. It is attached to the beams once the plywood is installed. Using a harness and a tether are not very suitable for installing the plywood and the guardrail. Problem with SAFETY: - The absence of a fastener is justified. - Insufficient vertical air clearance. - Absence of training in using the harness. - Absence of inspection of the harness. Problem with PRODUCTIVITY: - Installation time of a fastener or a lifeline. - Tethers that hinder and slow down the work of the operators. Mills SOLUTION: - Install the Mills GCC as a collective protection at the edge of the formwork from the towers, before the installation of formwork. -Work above a bed of close secondary beams: P11/MP3. - Ideally: use formwork half-panels to limit MSK conditions and wind surface area. For the 1 st time assemble and disassemble your conventional formwork on towers with collective protection ... AFTER www.mills.fr BEFORE