The complete harness-free safety solution…

For the 1st time assemble and disassemble your conventional formwork on towers with collective protection…

Today, there is a risk of falling from a height when fitting guardrails at the edge of the formwork. It is attached to the beams once the plywood is installed. Using a harness and a tether are not very suitable for installing the plywood and the guardrail.

Problem with SAFETY:

•  The absence of a fastener is justified.
• Insufficient vertical air clearance.
• Absence of training in using the harness.
• Absence of inspection of the harness.

Problem with PRODUCTIVITY:

• Installation time of a fastener or a lifeline.
• Tethers that hinder and slow down the work of the operators.

Mills SOLUTION:

• Install the Mills GCC as a collective protection at the edge of the formwork from the towers, before the installation of formwork.
• Work above a bed of close secondary beams: P11/MP3.
• Ideally: use formwork half-panels to limit MSK conditions and wind surface area.

See the technical documentation: 

Touréchaf + GCC + MP3 / P11 = the complete solution for an integral assembly without the falsework’s and formwork’s harness…
> 100% safe,
> 20% estimated gain in productivity!